system_worked
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: General system worked on:, type: esriFieldTypeString
, Coded Values:
[Gas Collection System: Gas Collection System]
, [Leachate System: Leachate System]
, [Flare: Flare]
, ...2 more...
)
system_other
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: System worked on:, type: esriFieldTypeString
)
desc_items
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Describe the items and the corrective action performed for the mentioned maintenance issue, type: esriFieldTypeString
)
newpumpdescription
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Use this when installing a pump into a location that is not currently equipped with a pump, type: esriFieldTypeString
)
swapdescription
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Use this when pulling an existing pump and either servicing and returning, or
installing a replacement spare pump., type: esriFieldTypeString
)
swap_pumpserialno
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Pump being installed Pump Serial Number:, type: esriFieldTypeString
)
swap_pulledpumpserialno
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Serial Number of Pump being Pulled:, type: esriFieldTypeString
)
swap_pumptype
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Installed Pump Type:, type: esriFieldTypeString
, Coded Values:
[QEDAP4: QED AP4]
, [QEDAP4Ultra: QED AP4 Ultra]
, [QEDAP4HighTemp: QED AP4 High Temp]
, ...3 more...
)
pulldescription
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Use this form when pulling an existing pump and do not plan on reinstalling
a pump in the structure, type: esriFieldTypeString
)
pull_notes
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Notes for pump being installed, type: esriFieldTypeString
)
dt_note
(
nullable: true, editable: true, defaultValue: null, length: 255, alias: Take temperature readings in 10' incraments starting at 10' below measured
fluid level and continue until bottom of well. If less than 10' of fluid present,
record temperature at halfway point between fluid level and bottom., type: esriFieldTypeString
)
dt_topofcasing
(
nullable: true, editable: true, defaultValue: null, alias: Top of Casing:, type: esriFieldTypeDouble
)